Safety Summary - Delta A6000 User Manual

USER MANUAL
A6000
AC POWER SOURCE
The following general safety precautions must be observed during all phases of operation, service,
and repair of this instrument. Failure to comply with these precautions or specific WARNINGS given
elsewhere in this manual will violate safety standards of design, manufacture, and intended use of
the instrument.
Delta assumes no liability for the customer's failure to comply with these requirements.
BEFORE APPLYING POWER
Verify that the product is set to match with the line voltage.
PROTECTIVE GROUNDING
Make sure to connect the protective grounding to prevent an electric shock before turning on the
power.
NECESSITY OF PROTECTIVE GROUNDING
Never cut off the internal or external protective grounding wire, or disconnect the wiring of protective
grounding terminal. Doing so will cause a potential shock hazard that may bring injury to a person.
FUSES
Only fuses with the required rated current, voltage, and specified type (normal blow, time delay,
etc.) can be used. Do not use different fuses or short-circuited fuse holders. To do so might cause a
shock or fire hazard.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the instrument in the presence of flammable gases or fumes.
DO NOT REMOVE THE COVER OF THE INSTRUMENT
Operating personnel must not remove the cover of the instrument. Component replacement and
internal adjustment can be done by qualified service personnel only.
When install or take off external terminals with hazard voltage, AC input voltage must be cut
off or take action to make safety isolation.
2 │ www.deltaww.com

Safety Summary