Series/Parallel Output Setting; Voltage Parallel Single Phase Output - Delta A6000 User Manual

USER MANUAL
A6000
AC POWER SOURCE

3.5 Series/parallel Output Setting

At main manual, press
mode, AC source outputs according the voltage and frequency set at main manual.
Measurement values are shown at the lower position of the screen. Following explains the
meaning of measurement information at different output mode (series or parallel operation)

1. Voltage parallel Single phase output

At parallel mode, no individual phase measurement values shows, voltage
measurement value is the average voltage of two phase, and current measurement value
is the sum of two phase current. Individual phase measurement values can be queried
through GPIB, RS232 interface.
Parameter definition of output setting:
 V : Alternative current output voltage (Vrms), unit is volt.
 F : Output frequency, unit is Hertz.
Parameter definition of measurement:
 V : Voltage (Vrms), voltage measurement value (root mean square), unit is Volt.
 I : Current (Irms), measurement value use Irms as unit.
 F : Frequency, measurement value use Hz as unit.
 P : Power, measurement vale use Watt as unit.
 Ip : Peak current measurement value. Unit is Ampere.
 Is : Surge current measurement value. Unit is Ampere.
23 │ www.deltaww.com
to change editing (setting) or output mode. At output