Ups Operating Instructions; Ups Controls And Indicators; Figure 6-1. Ups Controls And Indicators - Eaton 93PM UPS Installation And Operation Manual

Chapter 6

UPS Operating Instructions

This section describes how to operate the UPS.
6.1

UPS Controls and Indicators

The controls and indicators identified and described in this section are used to set up, control, and monitor UPS
operation. Figure 6-1 shows the control panel location on the front door of the UPS. Figure 6-2 and Figure 6-3
show the UPS breakers.
Control Panel
Door Latch

Figure 6-1. UPS Controls and Indicators

Eaton 93PM UPS (20–50 kW, 480V Four Wire – 50 kW Frame) Installation and Operation Manual P-164000540—Rev 4
NOTE 1 Before starting the UPS, ensure all installation tasks are complete and a preliminary
startup has been performed by authorized service personnel. The preliminary
startup verifies all electrical interconnections to ensure the installation was
successful and the system operates properly.
NOTE 2 Read this section of the manual and have thorough knowledge of UPS operation
before attempting to operate any of the controls.
www.eaton.com/powerquality 6-1