Figure 4-2. Removing The Sidecar Pallet Skids And Supports - Eaton 93Pm Ups - Eaton 93PM UPS Installation And Operation Manual

20–50 kw (480v four wire) – 50 kw frame

Table of Contents

Sidecar Rear

Cabinet Support

Figure 4-2. Removing the Sidecar Pallet Skids and Supports – Eaton 93PM UPS

Turn each jacking bolt consecutively, two full turns, until the pallet skids clear the floor by approximately

3 mm (1/8").

7 .

Remove the hardware loosened in Step 4.

If a sidecar is attached to the UPS, remove the hardware loosened in Step 5.

Pull the pallet skids out from under the metal angle supports without disturbing the jacking bolts. Recycle

the pallet skids and hardware in a responsible manner.

CABINET MAY FALL. Do not loosen the hardware attaching the front supports to the cabinet base.

The cabinet must be lowered by the jacking bolts before the supports can be removed.

10. Carefully and evenly lower the cabinet by turning each jacking bolt consecutively two full turns

(maximum) until the casters contact the floor and the cabinet is no longer supported by the jacking bolts.

11. After the UPS is resting on the floor, remove the jacking bolts and floor protectors. Recycle them in a

responsible manner.

12. Remove the cabinet support bolts fastening the front, rear, and side cabinet supports together and

remove the side supports (see Figure 4-1).

13. If a sidecar is attached to the UPS, remove the bottom screw securing the sidecar front panel. Lift the

panel straight up to remove from the panel hanger brackets at the top of the cabinet.

Eaton 93PM UPS (20–50 kW, 480V Four Wire – 50 kW Frame) Installation and Operation Manual P-164000540—Rev 4

Sidecar

Pallet Skid

Sidecar Skid

Mounting Bolts

(2 places front)

(2 places rear)

CAUTION

UPS System Installation

Sidecar Front