Explanation Of Symbols - 3M PELTOR PIC-100 NA User Instruction

6.3. STATUS AND CHANNEL LIGHTS
6.3.1. GENERAL
The indicator lights are used to present status of functions and
procedures.
A light can be off, on or blinking and can have different colors.
6.3.2. LED INDICATOR LIGHT DESCRIPTIONS
LED Indicator lights in
7.
Recycling Symbol. Recycle this product at a recycling station for
electrical and electronic equipment.
NOTE: Other symbols/decals may occur on the product due to
certification requirements for some commercial areas.
8.
8.1. GENERAL
The following point covers the main actions to make the PIC-100
headset ready for operation.
Follow instructions provided in chapter 8.2, chapter 9 and chapter 10.
• Check battery status
Charge or replace the battery if required
• Prepare the earplugs
Select and fit appropriate eartips
• Connect the headset to the SCU
• Attach the SCU
• Fit the earplugs and adjust earhooks
Adjust the cable
• Power on the SCU
• Carry out a real-time fit test
FP3881REVA_6sidedcover_32sidedinserts_4 x 6_2022-08-24.indd 5 FP3881REVA_6sidedcover_32sidedinserts_4 x 6_2022-08-24.indd 5
Description
illustrations
Off.
On (dimmed light).
On (white).
On (color).

EXPLANATION OF SYMBOLS

SETUP
8.2. BATTERY
8.2.1. GENERAL
The figure below shows battery pack removed from the SCU.
The PIC-100 Battery should be charged before first use. The
product will indicate low battery status with an audio message "low
battery", when less than one hour of battery life remains. The audio
message will repeat every five minutes.
Charging shall be done by means of a USB cable or in an optional
3M™ PELTOR™ PIC-100 Charging Station.
8.2.2. REMOVE/INSTALL BATTERY PACK
Remove battery pack
1. Turn the SCU over so that the SCU clip is facing up.
2. Slide the battery out from the bottom of the SCU by pushing
on the grips (1) located in the SCU clip window.
3. Lift the SCU clip slightly if needed.
EN
1
5
2022-08-24 08:30:26 2022-08-24 08:30:26