Troubleshooting - 3M PELTOR PIC-100 NA User Instruction

To power on, press and hold the Power/Menu button for a minimum
of 5 seconds. Headset must be connected to the SCU to power on.
3M™ PELTOR™ CH-3 Headset compatible models:
Article number
MT74H52A-111
MT74H52B-111
MT74H52P3E-111
FP3881REVA_6sidedcover_32sidedinserts_4 x 6_2022-08-24.indd 17 FP3881REVA_6sidedcover_32sidedinserts_4 x 6_2022-08-24.indd 17
Description 3M ID
3M PELTOR 7100203638
TM TM
CH-3 FLX2 Headset
with Built-In PTT,
Headband, Yellow
3M PELTOR 7100205729
TM TM
CH-3 FLX2 Headset
with Built-In PTT,
Neckband, Yellow
3M PELTOR 7100203150
TM TM
CH-3 FLX2 Headset
with Built-In PTT,
Carrier attached,
Yellow
The 3M™ PELTOR™ FLX2 Cable & the compatible CH-3 headsets
function like the PIC-100's standard headset except for a few
operational differences.
• Environmental listening operation is disabled. "Environmental
volume" is removed from the menu (Section 1. "Environmental
volume" no longer applies).
• Daily check and real-time fit testing operation are disabled.
"Eartip selection" and "Calibration status" is removed from the
menu (Section 6. "Eartip selection" and Section 14.
"Calibration status" no longer apply).
• When the PIC-100 headset is paired to a two-way radio, push
the PTT on the radio to transmit.
1 Environmental volume
16 Advanced settings:
Bluetooth Streaming
®
2 Radio volume
15 Advanced settings:
Bluetooth Call
®
3 Bluetooth
14 Calibration status
4 Bluetooth
13 Software version
5 Battery status
12 Reset default menu
6 Eartip selection
11 Language
7 Bluetooth
10 Automatic power off
9 Delete all paired devices 8 VOX sensitivity
14.

TROUBLESHOOTING

Problem Possible Issue/Solution
The SCU will Make sure the battery in the SCU is fully
not power on. charged and connected to a headset.
Poor battery. Replace the battery.
I can't get the fit Conduct a daily check to check the
test to give me integrity of the headset microphones and
a PAR. wires. If the earpieces pass, follow the
fit-test procedures and try again.
Headset unable Ensure the conditions are suitable for
to pass the daily conducting the daily check. If earpiece(s)
check. still do not pass the daily check, do not
conduct real-time fit tests or rely on the
fit-test results. Contact your supervisor.
You may need to replace with a new
calibrated headset.
I hear a beeping All 4 channels are occupied/busy or no
sound when other PIC-100 headset users are in
attempting to range. Repeat transmission until a
transmit using channel becomes available.
radio
communication
PTT or VOX.
EN
Call volume
®
Streaming volume
®
pairing
®
17
2022-08-24 08:30:30 2022-08-24 08:30:30