Table of Contents
Advertisement
Connecting to a network
You can remotely control the VR-400UHD from a computer that's on the same network.
Using remote control
There are two ways to remotely control this unit.
Using the WebRCS Web app
By inputting the specified URL into your Web browser to launch the
WebRCS Web app, you can control the VR-400UHD from your Web
browser.
See "WebRCS Web app" (p. 32) for details.
Sending commands from your computer
You can use Telnet to operate the VR-400UHD remotely over a LAN
(TCP/IP protocol).
See the "Remote Control Guide" (Roland website) for details on
commands that you can send.
VR-400UHD network settings
1.
From the [SETUP] button, touch <Network> in the
<System> tab.
The System Setup screen appears.
2.
Touch <DHCP> to configure the method of acquiring
network information.
Value
Explanation
Information required for connecting to the network such
Client
as the IP address from the DHCP server on the LAN is
automatically acquired.
Enables the DHCP server function. This automatically
assigns the information from the VR-400UHD that's
Server
required to connect to the network, such as a computer
on the LAN.
Selects how to configure the IP address, subnet mask
Static
and default gateway.
When DHCP = Static
3.
Configure the parameters in "Static Address" according
to the network.
Setting a password
Here's how to set the password used for connecting to the network.
1.
From the [SETUP] button, touch <Password> in the
<System> tab.
The System Setup screen appears.
2.
Check whether a password is set in the "Password State"
parameter.
Display
Explanation
Not set
Password not set
Enabled
Password set
3.
To edit the password, touch <Current Password> and
enter the current password.
Use the touch keyboard to enter the password. Once you've
finished inputting, touch <Accept> on the touch keyboard.
4.
Touch <New Password> to enter a new password.
Use the touch keyboard to enter the password. Once you've
finished inputting, touch <Accept> on the touch keyboard.
* Passwords can contain up to eight single-byte alphanumeric
characters or symbols.
5.
Touch <Set Password>.
This registers or changes the password.
Ø
Go to step 4
Ø
Go to step 3
29
Advertisement
Table of Contents
