Table of Contents
Advertisement
Video follow audio screen
Here you can make settings for the Video Follows Audio function. "Video follows audio" is a function that automatically switches to the desired scene when
the unit detects audio input that matches specific conditions.
Setting
Value
Common
PGM/PGM1, PST/PGM2, Both
Destination
Duration (sec)
3–5–30
Sense (dB)
Mic 1–6
Line 1, 2
-50– -16–0
HDMI
USB
Slot 1–8
This registers the detailed conditions (slots 1–8) for Video Follows Audio.
Switch
Disabled, Enabled
Recall Scene
1-1–8-8
This specifies the conditions for detecting audio, for each input. The scene changes when audio is detected that meets the
Condition
conditions on all inputs.
Mic 1–6
Presence
Line 1, 2
Absence
HDMI
Ignore
USB
Priority
Slot Swap
Swaps (exchanges) the slot settings.
Source
Slot
Slot
Destination
Execute
–
[HOME] button
Explanation
(bold text: default value)
Specifies the video bus used for Video Follows Audio.
Specifies the time until audio detection resumes after the scene finishes switching.
Sets the detection level for audio, for each input.
When the input audio exceeds the detection level, the indicator next to the input box for the
value lights up.
Enables/disables the slot. If multiple slots are enabled, audio is detected starting from the
lowest slot number.
* When Video Follows Audio is on, the "Switch" setting is enabled.
Sets the scene that's outputted when the input audio meets the conditions specified by the
"Condition" parameters.
The detected audio exceeds the level set in the "Sense (dB)" setting.
The detected audio is less than the level set in the "Sense (dB)" setting.
Ignores audio detection.
1–Slot 8
Specifies the slot number used as the swap source.
1–Slot 8
Specifies the slot number used as the swap destination.
Swaps (exchanges) the slot settings.
Ó
VFA <SETUP> on audio mixer screen
Parameter list
47
Advertisement
Table of Contents
