Table of Contents
Advertisement
Formatting a USB flash drive
The first time that you use a USB flash drive, you must use the
VR-400UHD to format it.
NOTE
¹ You may not be able to normally use USB flash drives on the
VR-400UHD that are formatted on a different device. Be sure
to format the media on the VR-400UHD (in FAT32 format).
¹ Never turn off the power or remove the USB flash drive while
the message "Processing. " is shown.
¹ When you format a USB flash drive, all data on that USB flash
drive is erased. If the drive contains important data, back it up
to your computer before you format the drive.
1.
Connect the USB flash drive to the USB HOST 2 port.
Rear panel
* Ensure that the USB flash drive is oriented
correctly, and insert it all the way into the port.
Do not use excessive force.
2.
From the [SETUP] button, touch <Format USB Memory>
in the <System> tab.
A confirmation message appears.
* To cancel, touch <Cancel>.
3.
Touch <Execute>.
Formatting is executed. "Done. " is shown once the operation is
finished.
4.
Touch <OK> to close the message.
Preventing unintended operation
(panel lock)
You can lock the controls and screen of this unit to prevent accidental
operations (panel lock function).
1.
From the [SETUP] button, touch <Panel Lock> in the
<System> tab.
2.
Touch the screen to select a value.
Value
Explanation
Disabled
Unlocks the panel.
Locks the controls and screen, so that all operations are
All Lock
disabled.
LCD Lock Locks the screen and disables screen touch operations.
Locks the panel/screen controls related to scene editing,
Edit Lock
which disables editing operations.
This enables the panel lock function.
Disabling the panel lock
1.
Hold down the [EXIT/ALT] button and press the [SETUP]
button to show the Setup screen.
2.
In the <System> tab, touch <Panel Lock>.
3.
Touch the screen to select "Disabled".
This disables the panel lock.
Other functions
27
Advertisement
Table of Contents
