Roland Audio Canvas UA-100 User Manual page 7

Effect Type Selector
This knob selects the type of preset effect.
The UA-100 contains four preset effects. These are generally controlled from
your computer using the UA-100 Controller, but you can also use this Effect
Type Selector to make simple effect settings.
When controlling the effects from your computer, set the Effect Type Selector to
the [PC] position.
For details refer to "About the Effect Type Selector" (p. 8).
Effect Controller 1/2, 3/4
These knobs adjust the parameters of the effect that is selected by the Effect Type
Selector. The effect parameters assigned to each controller will depend on the
effect type.
When the Effect Type Selector is in the [PC] or [BYPASS] position, the Effect
Controller settings will not function.
For details refer to "About the Effect Controllers" (p. 9).
Line Output Volume
This knob adjusts the volume that is output from the Headphone Jack and the
rear panel Line Output Jacks. Rotating the knob counterclockwise will decrease
the volume, while rotating it clockwise will increase the volume. However,
depending on the settings of the UA-100 Controller or the Effect Type Selector,
the signal from the Line Input Jacks may be output directly, so that it will not be
possible to adjust the volume.
Output Level Indicators
The number of LED's that light will depend on the output from the Headphone
Jack and the rear panel Line Output Jacks. If the red LED lights, you should
lower the Line Output Volume.
Power Indicator
Lights when the power is on.
Power Switch
Press this switch to turn the power on/off.
Headphone Jack
A pair of headphones can be connected to this jack. Even if headphones are
connected, sound will still be output from the rear panel Line Output Jacks.
Front Panel
7