Roland Audio Canvas UA-100 User Manual page 15

Mixer window
When you click [Mixer] in the main window, the mixer window will appear. Here you
can set the volume of the line input and of the input from the computer, adjust the
volume of the output from the UA-100, and select the output source to specify how the
signal will be routed and processed.
fig.02-04e.eps_70
* The diagram shown is for when the Effect Type Selector is at [PC]. The content that can be
controlled in the Mixer window will depend on the setting of the Effect Type Selector.
INPUT
INPUT in the upper left contains controllers (knobs) that control the pan (left/
right proportion), Send 1 (level of the signal sent to system effect 1), and
Send 2 (level of the signal sent to system effect 2). The Sub button is used
to switch the Sub fader on/off.
In the lower are the Main faders which control the levels of Mic1/GUITAR,
Mic2, Wave1, and Wave2. Each fader has a Mute and a Solo button.
SYSTEM EFFECT
SYSTEM EFFECT shown in the upper middle of the screen contains two
controllers (knobs) that control the system effect levels.
EFFECT
EFFECT lets you choose between the two Insertion Effect modes: Compact
Effects Mode or Full Effects Mode. To apply an effect, click the appropriate
effect select button (LINE, MIC1, MIC2, WAV1, WAV2, SYS1, SYS2).
EASY SETTING
The EASY SETTING buttons let you automatically set input sources and output
routings simply by pressing a button.
OUTPUT
OUTPUT lets you select the output sources, and control the master output level.
Master Source Selector (Source Select: white) selects the source to be
monitored. At the right, Wave Source Selector (Source Select: red) selects
the source to be recorded.
About the UA-100 Controller
For details on the Mixer
window, refer to the UA-
100 Controller Help.
15