Roland Audio Canvas UA-100 User Manual page 22

Recording Vocals
Prepare for Recording
1
Start up your sequencing software, and open a new song.
2
Select Roland UA-100 Wave as the port for the audio track to be recorded.
If you are using a sequencer such as the Cakewalk series and need to select the source
in the track, select either Left 1:Roland UA-100 Wave or Right 1:Roland UA-100
Wave.
fig.cw-uasource.e.eps_60
3
In your sequencing software, select the track to be recorded.
4
If your microphone has a switch, turn it on. Speak or sing into the microphone, and
gradually rotate the Mic 1/Guitar Input Volume knob clockwise.
Make sure that the input level peak indicator lights in green. If it lights in red, the input
level is too high. Adjust the Mic 1/Guitar Input Volume so that the level is as high as
possible without causing the input level peak indicator to light in red.
22
If Roland UA-100 Wave
is not selected as the port
for recording, the UA-100
has not been set correctly
to the audio device of the
sequencing software. For
details on settings for the
audio device, refer to the
manual for your
sequencing software.