Points To Check For The Ua-100 Controller - Roland Audio Canvas UA-100 User Manual

Troubleshooting
The UA-100 Driver Is Not Installed Correctly.
Follow the steps for "Deleting the UA-100 Driver" in the Getting Started to delete the
UA-100 driver from the computer, then refer to "Connections and Installation of the
Driver" in the Getting Started to install the UA-100 driver again.

Points to Check for the UA-100 Controller

Does Not Start Up
Is the UA-100 Driver Installed?
In order to use the UA-100 Controller to operate the UA-100, the UA-100 Driver must
be installed. For the installation procedure, refer to "Connections and Installation of the
Driver" in the Getting Started.
Is the Power of the UA-100 Turned On?
The UA-100 Controller cannot be used if the power of the UA-100 is not turned on.
Refer to "Connections and Installation of the Driver" in the Getting Started, and make
sure that connections have been made correctly. Turn on the power of the UA-100.
Can't Record Audio.
Has the Input Mode Appropriate for the Input Source Been
Selected?
If you are recording from Line Input, set the Mic/Guitar Select Button of the Mixer or
VT Mixer window of the UA-100 controller to the Line position to select Line Input.
Similarly, if you are recording from Mic Input, set the Mic/Guitar Select Button to the
Mic/Guitar or Mic1+Mic2 position.For details refer to "Using the UA-100" (p. 19) and
UA-100 Controller Help.
Are the Faders Raised?
In the Mixer or VT Mixer window of the UA-100 controller, raise the level of the Main
Fader or Wave Output Fader to increase the volume of the signal that you are
recording. For details refer to "Using the UA-100" (p. 19) and UA-100 Controller Help.
Has the Wave Source Selector Been Set Correctly?
In the Mixer or VT Mixer function of the UA-100 Controller, set the Wave Source
Selector to the source that you wish to record. For details refer to "Using the UA-100"
(p. 19) and UA-100 Controller Help.
106