Chapter 2 Front-Panel Overview
Front-Panel Menu Reference
Configure the advanced measurement features on displayed channel.
•
Set the integration time for measurements on the displayed channel.
•
Set the channel-to-channel delay for scanning.
•
Enable/disable the thermocouple check feature (T/C measurements only).
•
Select the reference junction source (T/C measurements only).
•
Set the low frequency limit (ac measurements only).
•
Enable/disable offset compensation (resistance measurements only).
•
Select the binary or decimal mode for digital operations (digital input/output only).
•
Configure the totalizer reset mode (totalizer only).
•
Select which edge is detected (rising or falling) for totalizer operations.
Configure system-related instrument parameters.
•
Set the real-time system clock and calendar.
•
Query the firmware revisions for the mainframe and installed modules.
•
Select the instrument's power-on configuration (last or factory reset).
•
Enable/disable the internal DMM.
•
Secure/unsecure the instrument for calibration.
View readings, alarms, and errors.
•
View the last 100 scanned readings from memory (last, min, max, and average).
•
View the first 20 alarms in the alarm queue (reading and time alarm occurred).
•
View up to 10 errors in the error queue.
•
Read the number of cycles for the displayed relay (relay maintenance feature).
•
Store up to five instrument states in non-volatile memory.
•
Assign a name to each storage location.
•
Recall stored states, power-down state, factory reset state, or preset state.
•
Select the GPIB address.
•
Configure the RS-232 interface (baud rate, parity, and flow control).
36
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Store and recall instrument states.
Configure the remote interface.