Agilent Technologies 34901A User Manual page 66

Chapter 3 System Overview
Measurement Input
You can configure the event or action that controls the onset of each
sweep through the scan list (a sweep is one pass through the scan list):
• You can set the instrument's internal timer to automatically scan at
a specific interval as shown below. You can also program a time delay
between channels in the scan list.
Scan List (1 sweep)
Scan-to-Scan Interval
(0 to 99:59:59 hours)
• You can manually control a scan by repeatedly pressing
the front panel.
• You can start a scan by sending a software command from the
remote interface.
• You can start a scan when an external TTL trigger pulse is received.
• You can start a scan when an alarm condition is logged on the
channel being monitored.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Scan Count
(1 to 50,000 scans, or continuous)
3
t
from
63