Vulcan-Hart VHG-C Series Operation Manual page 9

VHG SERIES GAS FRYERS

When installing a quick disconnect you must also install a means for limiting the
movement of the fryer. This device will prevent the gas line or quick disconnect
from being strained. The restraining device should be attached to the cutout on the
back panel. See illustration for location.

The fryer must be installed with a connector (not supplied by Vulcan) complying with
the above codes.

The fryer must be installed with restraining means to guard against
transmission of strain to the connector. See illustration.

The fryer must be installed with the casters provided.

If the restraint is ever to be disconnected, first turn the gas supply off. If
disconnection of the restraint is necessary, reconnect this restraint after the fryer
has been returned to its originally installed position.
Check the level of the fryer by placing a level on top of the fryer after gas connections have
been made.
Ensure that the fryer is level front-to-back and side-to-side in the final installed position.
If using casters, lock the wheels after unit is level.
VULCAN
A
B
A Rear Of Fryer
B Strain Relief Chan Connection
(Chain supplied by others)
LEVELING THE FRYER
-9-
F-47678 Rev. A (3-20)