Vulcan-Hart VHG-C Series Operation Manual page 30

VHG SERIES GAS FRYERS
4.The display will indicate DRAINING.
When The fry tank is empty, turn on the
filter pump by pressing the FILTER
button for 3-4 seconds. Allow the pump
to filter the oil for a couple of minutes
before closing the drain valve.
FLUSH/RINSE AND DISCARD OIL
1.Follow filtering instructions 1-3, however do not put oil treatment media into the fryer. Drain the fryer oil into
the filter pan.
2.Attach the quick disconnect hose to the discard male quick disconnect fitting.
3.To discard the oil, place the nozzle end of the discard hose into a container that is large enough to retain the
discarded shortening. Press the filter switch behind the door to the "USE HOSE TO DISCARD ONLY" position. This
will allow all of the oil to be pumped through the hose only.
4.For flushing/rinsing the tank with filtered oil to remove the particulates that have accumulated, press the filter
switch behind the door to the "USE HOSE TO RINSE AND FILL" position. This will allow the oil to pass through the
hose and come in from behind the tank at the same time.
the filter pump is engaged.
5.With the power switch still ON; press and hold the filter button for at least 3 seconds and the Motor/Pump will begin
to operate.
6.Once the oil has been discarded completely and the filter pan is empty, press the filter button to turn off the
Motor/ Pump.
cause burns.
VULCAN
5. Close the drain valve. Fill tank with
new shortening.
7.Press the FILTER button again to
stop the filter pump. The display will
alternate from VATFULL? to PUSH V.
Confirm the oil is at the correct level
and press the PROGRAM(V) button.
8.The fryer will then begin heating the
oil to the desired temperature
setpoint.
Oil will immediately exit out of the nozzle end of the hose any time the hose in plugged in and
The hose connection will be hot due to the temperature of the oil that was discarded and can
-30-
6. The display will alternate from
FILLING to PUSH FLT. Fill to between
the MIN and MAX lines on the back of
the fryer tank. Oil will expand as it is
heated. Do not fill the fryer tank past
the MAX line.
F-47678 Rev. A (3-20)