Vulcan-Hart VHG-C Series Operation Manual page 32

VHG SERIES GAS FRYERS
4.The display will indicate DRAINING.
When The fry tank is empty, turn on the
filter pump by by pressing the FILTER
button for 3-4 seconds. Allow the pump
to filter the oil for a couple of minutes
before closing the drain valve.
FLUSH/RINSE AND DISCARD OIL
1.Follow filtering instructions 1-3, however do not put oil treatment media into the fryer. Drain the fryer oil into
the filter pan.
2.Attach the quick disconnect hose to the discard male quick disconnect fitting.
3.To discard the oil, place the nozzle end of the discard hose into a container that is large enough to retain the
discarded shortening. Press the filter switch behind the door to the "USE HOSE TO DISCARD ONLY" position. This
will allow all of the oil to be pumped through the hose only.
4.For flushing/rinsing the tank with filtered oil to remove the particulates that have accumulated, press the filter
switch behind the door to the "USE HOSE TO RINSE AND FILL" position. This will allow the oil to pass through the
hose and come in from behind the tank at the same time.
filter pump is engaged.
5.With the power switch still ON; press and hold the filter button for at least 3 seconds and the Motor/Pump will begin
to operate.
6.Once the oil has been discarded completely and the filter pan is empty, press the filter button to turn off the
Motor/ Pump.
cause burns.
7.Disconnect the discard hose. Be careful to let the hose drain before putting away. Close the drain valve and fill the
fry tank with new oil.
VULCAN
5. Close the drain valve. Fill tank with
new shortening.
7.Press the FILTER icon button again to
stop the filter pump. The display will
indicate VATFULL? PUSH CONFIRM.
Confirm the oil is at the correct level
and press the CONFIRM button.
8.The fryer will then begin heating the
oil to the desired temperature
setpoint.
Oil will immediately exit out of the nozzle end of the hose any time the hose in plugged in and the
The hose connection will be hot due to the temperature of the oil that was discarded and can
-32-
6. The display will alternate from
FILLING to PRESS FILTER. Fill to
between the MIN and MAX lines on
the back of the fryer tank. Oil will
expand as it is heated. Do not fill the
fryer tank past the MAX line.
F-47678 Rev. A (3-20)