Operate The Prism Iii Printer; Power On And Off The Prism Printer; Power On Or Off A Standalone Printer; Power On Or Off A Printer Connected To An Autoloader Or Autoprinter - Rimage Prism III User Manual

Operate the Prism III Printer

This section provides information needed to operate your Prism printer.

Power On and Off the Prism Printer

Power On or Off a Standalone Printer

1. Press the power switch on the rear of the printer. The printer powers on
and initializes.
2. Press the power switch again. The printer powers off.
Power Switch
Power On or Off a Printer Connected to an Autoloader or
AutoPrinter
Follow these steps if your Prism III printer is connected to an autoloader or
AutoPrinter:
Tip: The power switch on the printer must remain in the 'on' position.
1. Power on the autoloader or AutoPrinter. The printer powers on and
initializes.
2. Power off the autoloader or AutoPrinter. The printer powers off.
2001809_A

Place a Disc on the Printer Tray

1. Press the operator button to open the printer tray.
2. Place one disc on the rubber pad between the two retaining pins and
3. Press the operator button. The printer tray moves to the disc clamped
For more information visit rimage.com/support
the centering pin.
Important! Place the disc with the recording side facing down. The
recording side has a raised stacking ring close to the hub. If a disc
is inserted with the stacking ring facing up, the print head could be
damaged.
Tips:
• If the disc is resting on the retaining pins, the printer tray will not
close.
• The characteristics of the print pad and plate vary between the
standalone and automated models. The automated model has a
hole through the center of the plate; the standalone model does
not. All models have a centering pin.
position.
Plate
Centering Pin
Retaining Pins
Printer Tray
8