Section 5 - Accelerator And Brake Pedal Assemblies; Brake Pedal; Brake Pedal Removal; Brake Pedal Installation - Club Car TURF 272 2005 Maintenance Service Manual

SECTION 5 – ACCELERATOR AND BRAKE
PEDAL ASSEMBLIES
ý
DANGER
• See General Warning, Section 1, Page 1-1.
ý
WARNING
• See General Warning, Section 1, Page 1-1.

BRAKE PEDAL

See General Warning, Section 1, Page 1-1.

BRAKE PEDAL REMOVAL

1. Make sure key switch is OFF and the Forward/Reverse handle is in the NEUTRAL position. Remove the
key.
2. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 1, Page 1-2.
3. Place chocks under rear wheels and lift front end of vehicle with a chain hoist or floor jack. Place jack
stands under the outer front I-beam of the vehicle frame and lower the vehicle onto the jack stands
(Figure 5-2, Page 5-3). See following WARNING.
ý
WARNING
• Lift only one end of the vehicle at a time. Use a suitable lifting device (chain hoist or hydraulic
floor jack) with 1000 lb. (454 kg) minimum lifting capacity. Do not use lifting device to hold
vehicle in raised position. Use approved jack stands of proper weight capacity to support the
vehicle and chock the wheels that remain on the floor. When not performing a test or service
procedure that requires movement of the wheels, lock the brakes.
4. Remove the brake pedal assembly.
4.1. Remove the bolt (9) and nut (19) (Figure 5-1, Page 5-2).
4.2. Remove nuts (4), flat washers (6), bolts (7), and mounting blocks (5). If the mounting blocks (5)
show signs of excessive wear, or are damaged, replace with new ones.
4.3. Remove the nut (3) and brake stop bumper (2).
4.4. Lift pedal assembly through the floorboard (Figure 5-3, Page 5-3).

BRAKE PEDAL INSTALLATION

1. Insert the brake pedal assembly through the top side of the floorboard (Figure 5-3, Page 5-3) and install
the brake pedal stop bumper (2) and nut (3) (Figure 5-1, Page 5-2) but do not tighten.
2. Position and attach brake pedal assembly and mounting blocks (5) with bolts (7), washers (6), and lock-
nuts (4). Tighten to 70 in-lb (7.91 N·m) (Figure 5-1, Page 5-2).
3. Attach the equalizer rod (10) to the brake pedal assembly (1). Tighten to 17 in-lb (1.9 N·m).
4. Adjust the brake pedal. See Brake Pedal Adjustment on page 5-3.
5. Connect the battery cables, positive (+) post first, and tighten terminals to 12 ft-lb (16.3 N·m). Coat ter-
minals with Battery Terminal Protector Spray (CCI P/N 1014305.
2005 Turf/Carryall 272/472 and XRT 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
5
Page 5-1