Chapter 3: Calibration
from sheet 1
Boat show
mode
Factory
defaults
Hold down
to exit calibration
Dealer calibration - sheet 2
Boat show mode
CAUTION: Do NOT enable Boat Show Mode
Do NOT enable Boat Show Mode. This must be used only for
demonstration purposes.
Ensure that the Boatshow Mode is set to bS0 (disabled). If necessary, press the
or > button to achieve this.
<
Factory defaults
You can use this screen to reset the operating parameters to the factory default
values. Use the < and > buttons to make the required selection.
Note that the selection you make at this screen will be applied when you exit the
screen, so be sure you make the correct selection.
To retain the current values, ensure that the display shows NO .
If you want to apply the factory defaults, change the display to YES . If you do
this, the values you have set up will be overwritten by the factory defaults when
you leave this screen.
Leaving Dealer calibration
Hold down the
Dealer calibration and resume normal operation.
and
set
for approximately 2 seconds
and set buttons for 2 seconds to save your changes, exit
Press
or
to set to off (bS0)
Do NOT set to on (bS1)
Press
or
to either apply factory defaults or retain
current settings
(F1 = factory defaults, F0 = current settings)
25