Surface Mounting - Raymarine ST60+ Owner's Handbook Manual

Chapter 2: Installation
ST60+ instruments can also be mounted behind a suitably prepared panel, so that
just the instrument dial and buttons are visible.

Surface mounting

To surface mount your ST60+ instrument (see the
1. Ensure that:
• The selected location is clean, smooth and flat.
• There is sufficient space behind the location to accommodate the rear of
2. Apply the surface mount template (supplied at the rear of this handbook) to
the selected location and mark the centers for the fixing studs (1) and the
aperture (3) that will take the rear casing of the instrument.
3. Drill out the two 0.2 in (5 mm) fixing stud clearance holes (2).
4. Cut out the clearance hole (3) then remove the template.
5. Peel off the protective sheet from the self-adhesive gasket (4) then stick the
gasket into position on the rear of the instrument.
6. Screw the two fixing studs into the threaded sockets on the rear of the instru-
ment.
7. Mount the assembled instrument, studs, bezel and gasket into the panel.
Secure from behind with the thumb nuts (5).
Surface mounting
the instrument and connectors.
Surface mounting
4 1 2 1 3
illustration):
5 2 5
11