Maximum Wind Speed; Wind Speed Alarms; Display Illumination - Raymarine ST60+ Owner's Handbook Manual

Chapter 1: Operation & Maintenance

Maximum wind speed

The maximum wind speed is reset at power up and can also be reset manually by
pressing the > button for 3 seconds.

Wind speed alarms

An alarm condition occurs when the wind speed either exceeds the maximum
wind speed alarm level or falls below the minimum wind speed alarm level. An
alarm condition is indicated by a flashing alarm icon on the digital display and an
audible alarm at the instrument.
Pressing any button will cancel an alarm.
Switching alarms on and off
Use the
screen as required, then press the > button for approximately 1 second, to toggle
the alarm either on (i.e. so the alarm level is displayed) or OFF, as required.
Setting alarm levels
To set a wind speed alarm level:
1. Use the
alarm screen, as required.
2. Momentarily press both the < and > buttons to enter the level adjust mode
(indicated by the displayed value flashing).
3. Press either the < button or the > button to set the required wind speed.
4. Momentarily press both the < and > buttons to leave the level adjust mode
(indicated by the displayed value flashing).

Display illumination

When the instrument is first powered up, the display illumination is set to its
lowest (courtesy) level, to facilitate initial access to the buttons.
To adjust the level of display illumination:
1. Hold down the
nation-adjust mode.
2. There are four preset illumination levels. Momentarily press the
cycle through these levels until you reach the level you want.
3. Press any other button to leave the illumination-adjust mode.
The digital display will return to normal operation 7 seconds after the last button
Note:
press.
button to select either the maximum or minimum wind speed alarm
button to select either the maximum or minimum wind speed
button for approximately one second, to enter the illumi-
3
button to