Flush Mounting - Raymarine ST60+ Owner's Handbook Manual

12

Flush Mounting

The Flush Mounting Kit uses a low-profile bezel to reduce the fitted profile of the
instrument, to approximately 0.25 in (6 mm) above the panel fascia.
Fitting the flush mount bezel
In order to flush-mount your ST60+ instrument, you must first replace the
standard bezel with the flush mount bezel as follows:
1. Hold the instrument in both hands with the display towards you.
2. Using both thumbs, gently press an upper corner of the instrument from the
bezel, then remove the bezel from the instrument. Retain the rubber keypad
which is released when the bezel is removed.
3. Referring to the
seal (8) in the corresponding recess on the back of the flush mount bezel (7).
4. Place the instrument (11) face upwards on a flat surface, then place the rub-
ber keypad (10) in position around the display window (i.e. so that each but-
ton outline is located over its associated button on the instrument).
5. Place the keypad seal (9) in position on the keypad (i.e. so that the holes in the
seal accept the appropriate keypad buttons).
6. Place the assembled flush mount bezel and panel seal, in position on the
instrument, so that the rubber keys are correctly located in the holes on the
bezel, then clip the bezel and instrument together.
ST60+ Club House Wind Instrument Owner's Handbook
Fitting the flush mount bezel
illustration, insert the panel