Boat Show Mode; Factory Defaults; Leaving Dealer Calibration - Raymarine ST60 Tridata Owner's Handbook Manual

Calibration

Boat show mode

CAUTION:
Do NOT enable this mode. It must only be used for demonstration
purposes.
Ensure that the Boatshow Mode Use is set to OFF. If necessary, use the
trip

Factory defaults

You can use this screen to reset the operating parameters to the factory
default values. If you want to apply the factory defaults, ensure the
display shows YES, but if you want to retain the values you have set up,
ensure that the display shows NO. Use the
required selection.
The values you have selected will be applied when you exit this screen.

Leaving Dealer calibration

Hold down the
exit Dealer calibration and resume normal operation.
or key to achieve this.
reset
and
depth
trip
keys for 2 seconds to save your settings,
speed
and keys to make the
reset
41