8
There must also be a viable route for the transducer cable to be routed to the
instrument.
As you will need to manually rotate the Wine Vane as part of the linearization pro-
Note:
cedure, do not actually fit it in position yet.
Instrument
CAUTION: Keep the rear of the instrument dry
Keep the rear of instrument dry. Failure to observe this caution
could result in damage if water enters the instrument through
the breathing hole or comes into contact with the electrical
connectors.
Each instrument must be positioned where:
• It is protected against physical damage.
• It is at least 20 in (500 mm) from radio receiving equipment.
• There is reasonable rear access for installation and servicing.
With standard bezel
(surface mount)
With low profile bezel
ST60+ instrument dimensions
ST60+ Club House Wind Instrument Owner's Handbook
4.33 in (110 mm)
(flush mount)
4.90 in (124 mm)
0.93 in
0.6 in
(23.5 mm)
(15 mm)
0.25 in
1.4 in
(6.50 mm)
(35 mm)
D8146-1