Chapter 2: Installation; Planning Your Installation; Site Requirements; Wind Vane - Raymarine ST60+ Owner's Handbook Manual

Chapter 2: Installation

This chapter describes how to install and calibrate the ST60+ Club House Wind
instrument, and associated Wind Vane transducer.
The transducer is connected to the rear of the instrument.
For advice, or further information regarding the installation of this equipment,
please contact the Raymarine Product Support Department or your own National
Distributor.

2.1 Planning your installation

Before starting the installation, spend some time considering the best positions
for both transducer and instrument, such that the
installation guidelines

Site requirements

Wind Vane

The Wind Vane has a cable connected, and is supplied with a junction box and a
set of spade terminals.
The location for the Wind Vane must:
• Allow reasonable access for installation and servicing.
• Be as high as possible and away from any object which may shield the Wind
Vane or otherwise disturb the air flow.
• Provide a horizontal mounting surface. If a surface (e.g. mast top) is otherwise
suitable but not horizontal, make up a suitable wedged packing piece to pro-
vide the necessary horizontal surface.
2.7 in (68 mm)
are satisfied.
10.7 in (272 mm)
21.2 in (538.5 mm)
Site requirements
and the
1.5 in (38 mm)
7
EMC
D6495-2