Response Settings; Boat Show Mode; Factory Defaults; Leaving Dealer Calibration - Raymarine ST60 Owner's Handbook Manual

38

Response settings

The response values for both SPEED and VMG determine the frequency at
which information is updated. A low number provides a smooth response
and a high number a much livelier update.
Use the timer (decrement) and reset (increment) keys to set the
required value. Response values are from 1 to 15.

Boat show mode

CAUTION:
Do NOT enable this mode. It must only be used for demonstration
purposes.
Ensure that the Boatshow Mode Use is set to OFF. If necessary, use the
timer or reset key to achieve this.

Factory defaults

You can use this screen to reset the operating parameters to the factory
default values. Use the timer and reset keys to make the required
selection.
Note that the selection you make at this screen will be applied when you
exit the screen, so be sure you make the correct selection.
If you want to apply the factory defaults, ensure the display shows YES,
but if you want to retain the current values, ensure that the display
shows NO.

Leaving Dealer calibration

Hold down the speed and trip keys for 2 seconds to save your settings,
exit Dealer calibration and resume normal operation.
ST60 Speed Instrument Owner's Manual