Switching On - Raymarine ST60+ Owner's Handbook Manual

Chapter 2: Installation
The Wind Vane is supplied with sufficient cable already connected, to run from the
mounted position to the ST60+ Club House Wind instrument. The manner in
which you run the cable will depend on the locations of the transducer and
instrument. The following guidelines are provided:
• Where cables are fed through holes, always use grommets to prevent chafing.
• Secure long cable runs so they do not present a hazard.
• Although the transducer cable is fitted with spade connectors for direct con-
nection to the rear of the instrument, it may be necessary to remove these to
facilitate installation e.g. if you want incorporate a junction box in the cable
run or if the cable has to be routed through narrow apertures. Extra spade
connectors are provided, to replace any that are removed when running the
cable. When fitting spade connectors, prepare the cable as at (a) in the follow-
ing illustration, then fold back the wire strands and insert into the spade con-
nector as at (b). Ensure the wire strands do not extend beyond the rear of the
spade connector insulation, then crimp the connector to the wire.
Referring to the
connect the Wind Vane cable to the instrument.

2.3 Switching on

Switch on the power to your ST60+ instrument. When the power is on, you can
use the
Operation
Use the appropriate procedure in
the level you want.
Connections to ST60+ Club House Wind instrument
button to switch the instrument on and off as described in
.
50 mm
(a)
(b)
3 mm
Chapter 1, Operation
6 mm
D4467-6
illustration,
Chapter 1,
to set the backlighting to
19