Caution: Use The Correct Screws - Raymarine ST60+ Owner's Handbook Manual

Chapter 2: Installation

CAUTION: Use the correct screws

It is essential that only screws of the correct size are used to
secure the instrument to the bezel. Failure to observe this caution
could result in damage to both the instrument and the bezel.
7. Using the four, self-tapping screws (12) provided, secure the instrument and
bezel together. Fit the screws from the rear of the instrument and tighten
them sufficiently to secure the instrument and bezel together. DO NOT OVER-
TIGHTEN.
Fitting the flush mount bezel
Flush mounting procedure
Flush mount your instrument (see the
1. Assemble the ST60+ instrument and flush mount bezel as described under
Fitting the flush mount bezel
2. Ensure that:
• The panel on which you intend to mount the instrument is between
• The selected location is clean, smooth and flat.
7
0.12 in (3 mm) and 0.78 in (20 mm) thickness.
8 9
Flush mounting
.
10 11 12
illustration) as follows:
13