Boat Show Mode; Factory Defaults; Leaving Dealer Calibration - Raymarine ST60 Owner's Handbook Manual

Chapter 4: Calibration

Boat show mode

CAUTION:
Do NOT enable this mode. It must only be used for demonstration
purposes.
Ensure that the Boatshow Mode Use is set to bS0 (disabled). If necessary, press
either the vmg key or the tack key to achieve this.

Factory defaults

You can use this screen to reset the operating parameters to the factory default
values. Use the vmg and tack keys to make the required selection.
Note that the selection you make at this screen will be applied when you exit the
screen, so be sure you make the correct selection.
If you want to apply the factory defaults, ensure the display shows F1 , but if you
want to retain the current values, ensure that the display shows F0 .

Leaving Dealer calibration

Hold down the disp and true/app . keys for 2 seconds to save your changes, exit
Dealer calibration and resume normal operation.
33