Servicing - Rangemaster Classic 110 Deluxe Duel Fuel Users Manual & Installation

WARNING  SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.

Servicing

BEFORE SERVICING ANY GAS CARRYING COMPONENTS.
TURN OFF THE GAS SUPPLY
Check the appliance is gas sound after completion of
service. When checking for gas leaks do not use washing
up liquid - this can corrode. Use a product specifi cally
manufactured for leak detection.
Do not use re-conditioned or unauthorised gas controls.
Disconnect from the electricity supply before
commencing servicing, particularly before removing any
of the following: - control panel, side panels, hotplate
tray or any electrical components or covers.
Before electrical re-connection, check that the appliance
is electrically safe.
Note - References to LH and RH oven apply as viewed
from the front.
Contents
1 To Remove the Control Panel
2. To Remove Hotplate
3. To Remove Side Panels
4. To Remove light Switch
5 To Change an Ignition Switch
6. To Remove Clock
7. To Remove a Thermostat
8. To Change the Grill or Ceramic hob Controller
9. To Change Hotplate Taps
10. To Change Hotplate Burner Injector
11. To Change Hotplate Burner Electrode
12 To Remove or Change a Hotplate Burner.
13. To Remove an Oven Door
14. To Change Oven Door Outer Panel
15. To Change Oven Door Latch
16. To Adjust an Oven Door Catch Keep
17. To Change Oven Door Seal
18. To Remove Grill Element.
19. To Remove Oven Inner Back.
20. To Change Fan in Oven.
21 To Remove an Oven element Thermal Cut-Out.
22. To Remove Oven Element.
23. To Remove the LH Oven Bottom and Top Elements
24. To Replace the ceramic hob glass.
25. To Replace a Hob Element.
26. To change oven light bulb.
27 To Adjust the Oven Door Angle
1 To Remove the Control Panel
Disconnect from electricity supply.
Pull off all the control knobs.
Open the grill and right hand oven doors and remove
the 4 fi xing screws underneath the control panel.
Remove the handrail by removing the 2 end bracket
fi xing screws.
Remove the 2 cross-headed screws that were hidden by
the handrail end brackets.
The control panel should drop down slightly. It is held
34
at the top by two holes in the top edge one at each end
34
that locate on tags on the inner panel.
35
Clear the holes from the inner panel and pull the control
35
panel forward.
35
35
35
35
36
Disconnect the wiring from the rear.
36
Reassemble in reverse order. When replacing leads refer
36
to the wiring diagram. Check operation of timer.
36
2. To Remove Hotplate
36
Disconnect from electricity supply.
36
Caution
36
The ceramic hob material is much more sensitive
36
to scratches on the underside than the top.
36
Take care not to touch or scratch the underside of
37
the ceramic as this will weaken the material and
37
cause the top to shatter.
37
Remove the pan supports and burner heads. Remove
the screws holding the hotplate burners to the hotplate.
37
Remove the 6 screws and 2 studs holding the hotplate
37
tray to the cooker.
38
38
38
38
38
34