Programming Devices - Omron SYSMAC CS1W-CLK11 Operation Manual

Specifications and Configurations
Communications Cables
Relay Terminal Blocks
1-2-6

Programming Devices

Programming Device for the PC
10
The following shielded twisted-pair cables are recommended for Wired Con-
troller Link Network connections.
Model
Li2Y-FCY2 x 0.56 qmm
–
1 x 2 x AWG 20PE +
Tr.CUSN + PVC
#9207
ESVC 0.5 x 2 C-1362
ESNC 0.5 x 2 C-99-087B
Note Use the special connector provided with the Board to connect the Controller
Link Support Board to the network.
The following Relay Terminal Block can be used to make maintenance easier
by facilitating replacement of the Controller Link Unit after system operation
has begun.
Name
Relay Terminal Block for
Wired Controller Link Units
Note Normally, the communications cable must be disconnected from a Wired Con-
troller Link Unit to replace it. Doing this, however, will interrupt communica-
tions on the network, requiring that all node be turned OFF to ensure safety
before replacing a Unit. With the above Relay Terminal Block, a Controller
Link Unit can be replaced by turning OFF only the specific Unit being
replaced, i.e., without turning OFF any other Units. The communications
cables are left connected to the Relay Terminal Block and only the Relay Ter-
minal Block is removed from the Controller Link Unit. (The built-in terminating
resistance connected at the Units at the end of the network prevents using the
Relay Terminal Block on the end Units.) Refer to $SSHQGL[ & 8VLQJ WKH 5HOD\
7HUPLQDO %ORFN for details on using the Terminal Relay Block.
A Programming Device for the PC, the Controller Link Support Software, or
CX-Programmer are needed to use a Controller Link Network.
One of the following Programming Devices is necessary when using the auto-
matically setting data links or the message service.
Programming
Console
IBM PC/AT or
compatible
Manufacturer
Kromberg & Schubert,
Komtec Department
Draka Cables Industrial
Belden
Bando Densen Co.
Nihon Electric Wire &
Cable Co.
Model
CJ1W-TB101
Start-up node
or
+
CX-Programmer
Software switches (DM Area)
Section 1-2
Remarks
German company
Spanish company
USA company
Japanese company
Japanese company
Remarks
Cannot be used on the nodes
on the ends of the network
CPU Unit
Controller Link