Table of Contents
Advertisement
3.
Click
Connect
Software opens to the
Operate the Product Configuration Software as described in the PCS Help (click
Extron PCS Help
Figure 16.
Updating the Firmware
The Product Configuration Software can call the Firmware Loader utility, which provides a
way to replace the firmware that is coded on the control board of the unit without taking the
unit out of service.
Update the unit firmware as follows:
1.
Perform steps 1 through 6 of
download the firmware upgrade from the Extron website.
2.
Click
Run
figure
Extron website and starts the Extron Installation Program to extract the firmware file.
3.
Click
Next
identified in the
ATTENTION:
•
•
NOTES:
•
•
DTP T/R DP 4K 330 and DTP T/R DP 4K 230 Twisted Pair Extenders • Remote Control
(see
figure
15,
, on the previous page). The Product Configuration
2
Input/Output Configuration
).
Product Configuration Software
Installing the
in the
and
File Download
17,
on the next page). The PC downloads the firmware update from the
1
(see
). The program extracts the firmware files and places them in a folder
2
InstallShield Wizard
The extension of the firmware file must be .s19. Opening a file with an incorrect
extension may cause the device to stop functioning.
L'extension du fichier firmware doit être .s19. Si un fichier est ouvert avec une
mauvaise extension, l'appareil peut arrêter de fonctionner.
Note the folder to which the firmware file is saved. When downloaded from the
Extron website, the firmware is placed in a subfolder of:
•
64-bit Windows OS:
C:
•
32-bit Windows OS:
C:
The original factory-installed firmware is permanently available on the unit. If
the attempted firmware upload fails, the unit reverts to the factory-installed
firmware.
page (see figure 16).
Software, starting on page 14, to
dialog boxes (see
Security Warning
window.
\
\
Program Files (x86)
Extron
\
\
\
Program Files
Extron
Firmware
>
\
.
Firmware
.
18
Advertisement
Table of Contents
