Table of Contents
Advertisement
AC2000 802.11ac Wireless Access Point/Router WAC124
If you are not connected to the access point/router network but to the same network
as the access point/router, enter the IP address that is assigned to the access
point/router. If you do not know the IP address, see Find the IP address of the access
point/router on page 29.
The NETGEAR Business page displays. You are prompted to sign in with your
NETGEAR account.
If the access point/router is not connected to the Internet, you are prompted to sign
in with the local login credentials (see Log in to the access point/router when it is
not connected to the Internet on page 27).
3. Click the Login button.
The NETGEAR Account Login page displays.
4. Enter your registered email address and password and click the Login button.
The BASIC Home page displays.
5. Select ADVANCED > Advanced Setup > Port Forwarding / Port Triggering.
The Port Forwarding / Port Triggering page displays.
6. Select the Port Triggering radio button.
The port triggering settings display.
7. Click the Add Service button.
The Port Triggering Rule page displays.
8. Set up a new port triggering rule with a custom service or application by specifying
the following settings:
• Service Name. Enter the name of the custom service or application.
• Service User. From the Service User menu, select Any, or select Single address
and enter the IP address of one computer:
-
Any. This is the default setting and allows any computer on the Internet to
use this service.
-
Single address. Restricts the service to a particular computer. Enter the IP
address in the fields that become available with this selection from the menu.
• Service Type. Select the protocol (TCP or UDP) that is associated with the service
or application.
• Triggering Port. Enter the number of the outbound traffic port that must open
the inbound ports.
Router Mode: Manage Port
Forwarding and Port Triggering
239
User Manual
Advertisement
Table of Contents
