NETGEAR WAC124-100NAS User Manual page 150

AC2000 802.11ac Wireless Access Point/Router WAC124
The information in the heading of each of the four panes uses the following color
coding:
• Green flag. The settings are fine and no problems exist. For a radio, the WiFi
network is enabled and secured.
• Red X. A problem exists or the connection is down. For a radio, the WiFi network
is disabled or down.
• Orange exclamation mark. The access point/router cannot get an Internet
connection (for example, because a cable is disconnected), the WiFi network of
a radio is enabled but open (that is, it is unprotected), or another situation
occurred and requires your attention.
The following tables describe the fields of the panes.
Field
AP information pane
Hardware Version
Firmware Version
GUI Language Version
Serial Number
Operation mode
Field
LAN Port pane
To change these settings, see Router mode: Use the Setup Wizard on page 36 or Access point mode: Specify a
fixed LAN IP address on page 37.
MAC Address
IP Address
Connection
Maintain and Monitor the Access
Point/Router
Description
The access point/router hardware version, which is the model number WAC124.
The access point/router firmware version. If you update the firmware, the version
changes (see Update the firmware of the access point/router on page 134).
The access point/router language version for the local browser interface.
The serial number of the access point/router. This number does not change.
AP
Description
The MAC address that applies to the access point/router WAN (Internet) port.
The LAN IP address that the access point/router receives from an existing router
in your network or the static (fixed) IP address that you manually configured.
The type of Internet connection that the access point/router uses, which can be
DHCP Client (the default setting) or FixedIP.
150 User Manual