NETGEAR WAC124-100NAS User Manual page 153

AC2000 802.11ac Wireless Access Point/Router WAC124
(Continued)
Field
Firmware Version
GUI Language Version
Serial Number
LAN Port
MAC Address
IP Address
DHCP Server
Field
Internet Port pane
To change these settings, see, Router mode: Use the Setup Wizard on page 36 or Router mode: Manually set up
the access point/router Internet connection on page 38.
MAC Address
IP Address
Connection
Maintain and Monitor the Access
Point/Router
Description
The access point/router firmware version. If you update the firmware, the version
changes (see Update the firmware of the access point/router on page 134).
The access point/router language version for the local browser interface.
The serial number of the access point/router. This number does not change.
The single MAC address that applies to all four access point/router LAN ports
combined.
The IP address that applies to all four access point/router LAN ports through which
you can access the access point/router.
If the access point/router is in router mode, whether the DHCP server of the access
point/router is enabled (the default setting in router mode) or disabled (see Router
mode: Disable the DHCP server on page 118).
Description
The MAC address that applies to the access point/router WAN (Internet) port.
The WAN IP address that the access point/router receives from your modem or
the WAN IP address that you manually configured.
The type of Internet connection that the access point/router uses, which can be
DHCP Client (the default setting), FixedIP, PPPoE, PPTP, or L2TP.
153 User Manual