Table of Contents
Advertisement
AC2000 802.11ac Wireless Access Point/Router WAC124
Note: If you are not sure what the type of WAN connection of your modem is, contact
your ISP before you start the following procedure.
Figure 4. Connect the access point/router in default router mode to your modem
To connect the access point/router to a modem and log in to the local browser
interface for the first time:
1. Unplug your modem's power, leaving the modem connected to the wall jack for
your Internet service.
2. If the modem uses a battery backup, remove the battery.
3. Connect the Ethernet cable to the yellow Internet port on the access point/router.
4. Connect the other end of the cable to a LAN port on your modem.
5. If the modem uses a battery backup, put the battery back in.
6. Plug in and turn on the modem.
7. Power on the access point/router and check to see that the LEDs light.
Install and Access the Access
Point/Router in Your Network
20
User Manual
Advertisement
Table of Contents
