Western Digital Ultrastar Data60 Installation Manual page 48

Installation Guide
a. Orient the brackets so that the screw holes are between the two pins supporting the outer
rails as shown in the following image. There is a left and a right. Use the image below as
a guide for how to orient this bracket and mirror it for the other side. Notice the increased
distance between the top two screw holes and the lower screwholes and the flange being
oriented on the outside.
Figure 25: Rack Latch Bracket Installed
b. Use 6 of the included M5 x 12mm screws and the T15 Torx screwdriver to install each
bracket, 3 screws per bracket.
W hat to do next: T he rails are now installed. Proceed to
Chassis Installation (page 40)
5. Installation
5.3 Rails Installation
.
39