Western Digital Ultrastar Data60 Installation Manual page 47

Installation Guide
Option 1
install M5 x 12mm T15 Flat Head Torx screws
(with washers) to attach the rear cover
alignment bracket. The number of required
screws will vary depending on the bracket
type. Install additional M5 x 12mm T15
Flat Head Torx screws (with washers) to
attach the rear rail to the rack posts. Screw
locations are shown in the following image.
Tighten the rails screws to 3.38-3.61 Nm /
30-32 in-lbf.
Figure 23: Rear Screws Installation
Step 7 : Install the two rack latch brackets at the front of the rack.
: Using a Long T15 Torx Screwdriver,
Caution: Be careful to set the
screws properly in the cover
alignment bracket and rail to
prevent crossthreading.
5.3 Rails Installation
Option2: Using a Long T15 Torx Screwdriver,
install the screw plate to attach the rear
cover alignment bracket and the rear rail
to the rack posts. The screw locations are
shown in the following image. Tighten the rail
screws to 3.38-3.61 Nm / 30-32 in-lbf.
Figure 24: Screw Plate Installation
5. Installation
38