Western Digital Ultrastar Data60 Installation Manual page 58

Installation Guide
c. Open all of the baskets.
Figure 36: Open Baskets
d. Connect the Ethernet cable to the Ethernet port, and route the cable through each of the
baskets on the arm.
e. Connect the SAS cables to the SAS ports, and route them through the baskets one at a
time. Make sure to follow the labels to ensure they are connected to the proper ports.
f. Connect the power cable to the PSU.
Attention: Make sure the power cable is not connected to a PDU.
the system will power up when the cable is connected to a PSU. This is not
intended at this stage of installation.
5. Installation
5.6 Cable Installation
If it is,
49