Installation Guide
Returning to the first drive assembly, pinch the latch release and carefully press downward to
Step 5 :
fully seat the 3.5in HDD Assembly into the drive slot.
Figure 53: Seating the 3.5in HDD Assembly
Step 6 :
Repeat this action to fully install the remaining drive assemblies in the same order, from left-to-
right, rear-to-front.
Step 7 :
Now that the drives are installed into the chassis, test the installation by sliding the enclosure
in and out of the rack a minimum of three times. If the enclosure binds, catches, or displays any
incorrect motion or behavior retry the installation of the drives and chassis.
W hat to do next: T he drives are now installed. Proceed to
Shipping Screws Installation (page 68)
5. Installation
5.8 Drive Installation
.
65