Installer Checklist - Thermador Professional Pro Grand Series Installation Manual

Flame Image
Completely or mostly
yellow
Yellow tips on outer
cone
Soft blue
10 Installer checklist

Installer checklist

Final check.
Installer checklist
Specified clearances maintained to cabinet
surfaces.
Unit level – front to back – side to side.
Burner caps positioned properly on burner bases.
All packaging material removed.
Kick panel in place and screws secure.
Verify flame at each burner. Flame may need to
burn for several minutes to remove impurities from
the gas lines.
Verify that the ExtraLow® feature works and
relights around the entire burner.
INSTALLER: Leave the Home Connect®
instruction leaflet with the owner of the appliance.
In order to utilize the full feature potential of the
appliance, the owner should download the
Home Connect® (America) app on their smart
device and pair the appliance to the home's Wi-Fi
device. (Does not apply to 30" Range models.)
Gas supply
Gas Connection: ¾" (19 mm) N.P.T. with a min. ¾"
(19 mm) diameter flex line.
The appliance is connected only to the type of gas
for which it is certified for use.
Manual gas shut off valve installed in an accessible
location (without requiring removal of range).
Owner is aware of location of the gas shut-off
valve.
Unit tested and free of gas leaks.
If used on propane gas, verify that the propane gas
supply is equipped with its own high pressure
regulator in addition to the pressure regulator
supplied with the appliance.
Gas supply pressure does not exceed 14" W.C.
(34.9 mbar).
Measure
Verify that the regulator is set for the correct fuel. Retest
after adjustment.
Normal for LP gas
Normal for natural gas
Refer to the Use and Care Guide for information
about cleaning and protect exterior surfaces.
Electrical
Receptacle with correct over-current protection is
provided for service cord connection.
Proper ground connection.
Owner is aware of location of the main circuit
breaker.
Operation
Bezels centered on burner knobs, and knobs turn
freely.
Each burner lights satisfactorily, both individually
and with other burners operating.
Oven door hinges seated and hinge locks in proper
position. Oven handle and door is level and
centered. Door opens and closes properly.
Burner grates correctly positioned, level, and do
not rock.
INSTALLER: Write the model number and serial
number in the Use and Care Guide. Leave the Use
and Care Guide and Installation Guide with the
owner of the appliance.
Troubleshooting
See the Use and Care Guide for troubleshooting
information.
Customer Service 11 Customer Service
With any warranty repair, we will make sure your
Customer Service
appliance is repaired by an authorized service provider
using genuine replacement parts. We use only genuine
replacement parts for all repairs.
Detailed information on the warranty period and terms of
warranty can be found in the Statement of Limited Product
Warranty, from your retailer, or on our website.
If you contact Customer Service, you will need the model
number (E-Nr.) and the production number (FD) of your
appliance.
USA:
Installer checklist en-us
27