Electrical Requirements And Connection For Dual Fuel And Induction Models; Preparation For Power Connection - Thermador Professional Pro Grand Series Installation Manual

7 Electrical requirements and connection for DUAL FUEL and INDUCTION

Electrical requirements and connection for DUAL FUEL and INDUCTION models

models
The ranges are to be connected to a 240/208 VAC power
Electrical requirements and connection for DUAL FUEL and INDUCTION models
supply.
WARNING
An improper 240/208 VAC power supply will cause
malfunction, damage to this appliance, and possibly create
a condition of shock hazard.
If the correct power supply circuit is not provided, it is the
responsibility and obligation of the installer and user to
have a proper power supply connected.
This must be accomplished by a qualified electrician in
▶
accordance with all applicable local codes and
ordinances. It is the responsibility of the installer to
ensure compliance of local codes. In the absence of
local codes and ordinances, the power supply
connection shall be in accordance with the National
Electrical Code.
This appliance must be properly grounded.
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
▶
ON accidentally.
WARNING
Always disconnect appliance from the electric supply
either by disconnecting power cord or shutting off the
breaker at the service panel before servicing the
appliance.
Electrical installations and grounding must be in
¡
accordance with all local codes and ordinances, and/or
the National Electrical Code, as applicable.
A neutral supply wire must be provided from the power
¡
source (breaker) because critical range components
require it to operate safely and properly.
Required dedicated circuit
Models
All double oven and
induction ranges
All single oven non-induction
ranges except PRD364WIGx
PRD364WIGx
7.1 Preparation for power connection
WARNING
Risk of Electric Shock or Fire. Grounding through the
neutral conductor is prohibited for new branch-circuit
installations (1996 NEC), mobile homes, and recreational
vehicles, or in an area where local codes prohibit
grounding through the neutral conductor.
Electrical requirements and connection for DUAL FUEL and INDUCTION models en-us
Voltage US
240/208 50 AMP
240/208 30 AMP
240/208 40 AMP
Mount the receptacle securely to a wall stud, then seal
¡
around the receptacle's housing.
Observe all governing codes and ordinances when
¡
grounding. In the absence of these codes or ordinances
observe National Electrical Code ANSI/ NFPA 70
current issue. See the following information in this
section for grounding method.
Electrical wiring diagrams and schematics have been
¡
placed in the toe kick panel area of the range for access
by a qualified service technician. → Page 21
Dual Fuel models must be connected to the power
¡
supply utilizing one of the described methods. For all
methods of connection, the length of the cord or
conduit/wiring must allow the appliance to be slid
completely out of the cabinet without having to unplug
or disconnect the appliance from the power supply.
The recommended minimum free length of cord or
¡
conduit is 4 ft (1.2 m).
When using a receptacle it may be necessary to recess
¡
the receptacle's housing into the rear wall. Refer to
Local Electrical Code to determine the minimum volume
for all electrical / junction boxes. Follow all local
electrical codes and ordinances, and/or the National
Electrical Code, as applicable.
Canada Frequency
50 AMP 60 Hz.
40 AMP 60 Hz.
40 AMP 60 Hz.
Phase
Single
Single
Single
19