Electric Wiring Diagrams And Schematics; Installation Procedure; Installing The Low Backguard (Purchased Separately) - Thermador Professional Pro Grand Series Installation Manual

Mount the strain relief into the 1" (25.4 mm) diameter
6.
hole in the back panel located below the terminal block.
Route the wires up through the strain relief.
Secure the neutral, grounded wire of the supply circuit,
7.
to the center stud (silver colored) of the terminal block.
Secure the L2 (red) and L1 (black) power leads to the
8.
outside terminal studs (brass colored) with nuts.
Remove the green ground screw and serrated washer
9.
located beneath the terminal block. Screw one end of
the included white jumper wire to the chassis beneath
the terminal block with the green ground screw. Secure
the other end of the wire to the center stud of the
terminal block with a nut.
a
a Red / L2
b Ground link white jumper wire provided in small
bag
c White / neutral
d Black / L1
Tighten all connections and nuts securely, including the
10.
bottom nuts.
Reinstall the terminal block cover.
11.
c
d
b
7.4 Electric wiring diagrams and schematics
The electric wiring diagrams and schematics are attached
behind the toe kick panel, and should not be removed
except by a service technician, then replaced after service.
8 Installation procedure

Installation procedure

Installation procedure
8.1 Installing the low backguard (purchased
separately)
Installation methods will vary upon need. Before you begin
read these instructions carefully. Observe all local codes
and ordinances.
WARNING
Fingers or hands could get pinched when installing the
backguard. Severe injury could result.
Use extreme caution and wear thick protective gloves to
▶
avoid potential laceration to finger or hand while sliding
the backguard down onto the range.
WARNING
To reduce the risk of fire or injury to persons, check to
make sure all packaging has been removed from
accessory devices before use.
Installation procedure en-us
a
b
21