Unpacking And Moving The Appliance - Thermador Professional Pro Grand Series Installation Manual

en-us Prior to installation
In all cases, at least two (2) of the anti-tip bracket
¡
mounting screws must be fastened to a solid wood
surface.
Use appropriate anchors when fastening the mounting
¡
bracket to any material other than hardwood or metal.
Remove the anti-tip bracket from the literature packet,
1.
inside the box that was on top of the appliance.
Place the anti-tip bracket on the floor as shown. It may
2.
be placed on either the left or the right side.
Measure and mark the distance stated for your
3.
appliance model. Center the anti-tip bracket on the
marking.
→ "Anti-tip bracket location", Page 14
For walls, wall studs, or floors composed of solid wood
4.
or metal, drill ⅛" (3 mm) pilot holes.
Secure the anti-tip bracket to the floor and/or the wall
5.
stud using the (4) 1½" (38 mm) cross-head screws
provided.
When installing the appliance, ensure that the
6.
adjustable leg slides under the anti-tip bracket.
Anti-tip bracket location
30", 36" and 48" ranges
Note: The image shows all possible screw locations. Use
at least 2 of the 4 screws provided.
Model
30" Pro Harmony®
36" Pro Harmony®
36" Pro Grand®
48" steam models only
48" all other models
14
Value for "X"
1¾" (45 mm)
2³⁄₁₆" (56 mm)
3⅞" (98 mm)
1⅝" (41 mm)
1¾" (45 mm)
60" ranges
Note: The image shows all possible screw locations. Use
at least 2 of the 4 screws provided.
Model
60"
4.2 Unpacking and moving the appliance
CAUTION
Take the following precautions when handling the
appliance during installation.
DO NOT lift the unit by the oven door's handle, as this
▶
may damage the door hinges and cause the door to fit
incorrectly.
DO NOT lift the unit by the range's control panel.
▶
The unit is heavy and should be handled accordingly.
▶
Proper safety equipment such as gloves and adequate
manpower of at least two people must be used in
moving the unit to avoid injury and to avoid damage to
the unit or the floor.
Rings, watches, and any other loose items that may
▶
damage the unit or otherwise might become entangled
with the unit should be removed.
Hidden surfaces may have sharp edges. Use caution
▶
when reaching behind or under the unit.
DO NOT use a hand truck or appliance dolly on the
▶
back or front of the unit. Handle from the side only.
Unpacking the appliance
NOTICE:
DO NOT remove the control panel foam until the unit is
completely installed.
DO NOT lift on the control panel at any point during the
installation.
Remove the outer carton and packing materials from
1.
the shipping pallet.
Leave the protective film over brushed-metal surfaces,
2.
to protect finish from scratches, until the range is
installed in its final position.
Remove the grates, burner caps and oven racks to
3.
facilitate handling.
Value for "X"
2" (51 mm)