Installer Checklist - Thermador PRO-HARMONY P304 Installation Instructions Manual

iNSTALLER CHECKLIST
FINAL CHECK LiST
D Placement of unit,
D Specified clearances main-
tained to cabinet surfaces.
Q Unit tested and free of gas
leaks.
Q Gas supply pressure does not
exceed 14" W.C. (34.9 mb).
Q Unit Level - front to back -
side to side.
Q Burner caps positioned prop-
erly on sealed burner bases.
Q All packaging material re-
moved.
D
D
D
Island trim or backguard at-
tached. Backguard needed if
horizontal clearance to com-
bustible materials behind cook-
ing surface is less than 12".
Check door fit to oven cavity.
Reqnstall door if necessary (See
door reinstallation procedure at
the bottom of page 16.
Kick panel in place and two (2)
screws secure.
D
The griddle or grill plate and
frame is correctly positioned,
tilted slightly forward. (See page
10 for adjustment procedure.)
D
D
D
D
Receptacle with correct over-
current protection is provided
for service cord connection.
Proper ground connection.
Proper polarity at receptacle.
A NEMA 5-20,120 VAC recep-
tacle is used for P364GE gas
range model with electric
griddle having 20 AMP over-
current protection.
OPERATION
D All internal packing materials
removed. Check below grates
and grill pans and within
oven(s).
D If used on propane gas, verify
that the propane gas supply is
D
D
D
D
D
D
D
equipped with its own high pres-
sure regulator in addition to the
pressure regulator supplied
with the appliance.
Burner caps properly seated
into burner bases.
Bezels centered on burner
knobs, and knobs turn freely.
Each burner lights satisfacto-
rily, both individually and with
other burners operating.
Air Shutter adjustment for
proper flame made for Grill.
See Step 9 and Fig.9.
Griddle or grill is tilted
forward and does not rock (not
all models).
Oven door hinges seated and
hinge locks in proper position.
Door opens and closes prop-
erly.
Burner grates correctly posi-
tioned, level, and do not rock.
GAS SUPPLY
D
D
Connection: 1/2" N.P.T. with
a minimum 3/4" diameter
flex line - suggested length four
(4) ft., depending upon local
codes.
The appliance is connected only
to the type of gas for which it is
certified for use.
D
Manual gas shut off valve in-
stalled in an accessible loca-
tion (without requiring removal
of range).
18