Placing The Range - Thermador Professional Pro Grand Series Installation Manual

en-us Installation procedure
Remove the T-20 star-head screws in the front face of
1.
the included island trim.
Remove the T-20 star-head screws securing the trim to
2.
the side panels, and the T-20 star-head screws
securing the piece to the back panel. Lift up to fully
remove.
Align the back panel of the new accessory with the
3.
flanges on the range side panel's right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range.
Make sure the backguard's front face is outside the
4.
flange on the front side of the range.
22
Re-install screws removed previously.
5.
8.2 Placing the range
CAUTION
Unit is heavy and requires at least two persons or proper
equipment to move.
It is recommended to wear protective clothing during the
lifting process.
Wear gloves and long sleeves to protect hands and
▶
forearms from abrasion and potential scratches.
Take off watches and jewelry.
▶
Wear work shoes for foot protection.
▶
NOTICE:
To avoid risk of damage to the range oven door, do not lift,
push, or pull the range by holding the door handle.
Requirement: You have removed the oven door.
1.
CAUTION DO NOT attempt to lift the unit by
holding the oven's upper heating element.
Lift the range off of the packaging base. Reach inside
the top of the oven cavity to locate a ridged area near
the front of the oven.
Make sure that the circuit breaker is off and then plug
2.
the range cord into the electrical outlet.
Protect the floor and cabinetry.
3.