Adjusting The Leveling Legs; Adjusting The Toe Kick Panel - Pro Harmony® Models - Thermador Professional Pro Grand Series Installation Manual

Slide the range into the opening. Be careful not to
4.
damage countertops, floors, or warming drawer front.
Do not apply pressure to the cooktop when sliding the
range into position.
Install the oven door.
5.
Check proper installation.
6.
8.3 Adjusting the leveling legs
For proper performance, the range must be level. Priority
should be placed on ensuring that the oven cavity is also
level for optimum cooking performance.
NOTICE:
The top edges of the range's side panels must be on the
same or higher level as the adjacent countertop.
DO NOT operate the range if sides are lower than the
▶
adjacent cabinet. If the range is operated while at a
lower height relative to the adjacent cabinet, the cabinet
could be exposed to excessive temperatures, causing
damage to the cabinet and countertop.
Remove plastic protective coating from the side walls.
1.
Line up the range in front of the opening.
2.
Measure the countertop heights first with a tape
3.
measure and add an additional 1/16'' - 1/8'' (2-3 mm).
Rotate the legs using a 12" (305 mm) adjustable wrench
4.
on the flat sides of each foot.
Leveling legs should be adjusted so that the range
5.
sides are at the same or higher level as the adjacent
cabinet. Adjust the legs accordingly prior to pushing the
range back to its final location.
It may be necessary to reposition the electrical cord as
the range is pushed back to its final position. This may
be accomplished by carefully pulling on a rope or twine
looped around the electrical supply line as the range is
pushed back into its final installed position.
As the range is moved into its final, installed position,
6.
verify that the anti-tip bracket is in a position to engage
the range.
Look under the range to verify that both back legs are
‒
resting solidly on the floor.
Verify that one range leg is retained by the anti-tip
‒
bracket.
Leveling leg adjustment for 60" models
Height adjustments of the two rear caster legs are made
1.
by turning the 5/16'' socket located behind the front
frame.
– Rotation direction will vary depending on which side
of the appliance is being adjusted.
– The oven doors must be removed in order to access
the leveling socket for the rear wheels (see "Door
removal and adjustment"). On models with a warming
drawer, the socket for the left caster may be
accessed by pulling the warming drawer open.
With the range in the installed position, the final height
2.
adjustments are made to the two front legs to ensure
proper alignment to the counter top.
Lower the center leveling foot of the unit to help support
3.
the appliance weight.
8.4 Adjusting the toe kick panel - Pro
Harmony® models
Remove the toe kick panel screws using a T-20 star-
1.
head screwdriver.
Relocate the toe kick panel at one of the five screw hole
2.
positions. Reinstall the star-head screw.
Repeat with the remaining toe kick panel screws,
3.
assuring the toe kick panel is level.
Installation procedure en-us
23