Electrical Requirements And Connection For Dual Fuel Models - Thermador Pro Grand PRD364WDGC Installation Instructions Manual

Gas unit electrical connection
Electrical supply circuit requirements
NEMA 5-15 NEMA 5-20
N
N
G
G
Model Voltage
Pxx305Wx 120 VAC
Pxx366Wx 120 VAC
Pxx364WDx 120 VAC
Pxx364WLx 120 VAC
Pxx486WDx 120 VAC
Pxx486WLx 120 VAC
• Before you plug in an electrical cord, be sure all
controls are in the OFF position.
• A neutral supply wire must be provided from the
power source (breaker) because critical range
components, including the surface burner spark
reignition modules, require it to operate safely and
properly.
• All 120 volt models must be plugged into a mating 3-
prong, grounding-type receptacle. The receptacle
must be connected to a properly dedicated grounded
and polarized electrical power supply rated at
120VAC, Single Phase, 60Hz.
• Observe all governing codes and ordinances when
grounding. In the absence of these codes or
ordinances observe National Electrical Code ANSI/
NFPA No. 70 current issue, or the relevant Canadian
Electric Code, CSA C22.1-02.
• Power cord and receptacle
should protrude no more than
2'' (51 mm) from the rear wall.
NOTE: Plug styles may vary.
Page. 19
The cord supplied with the
gas ranges having an electric
griddle or grill requires a
NEMA 5-20 receptacle. All
other gas units require a
NEMA 5-15 receptacle.
Dedicated circuit Phase
15 Amps Single
15 Amps Single
20 Amps Single
20 Amps Single
20 Amps Single
20 Amps Single
2"
(51)
Electrical requirements and
connection for DUAL FUEL
models
9 WARNING
An improper 240/208 VAC power supply will cause
malfunction, damage to this appliance, and possibly
create a condition of shock hazard.
9 WARNING
This product must be properly grounded.
• Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being
turned ON accidentally.
• Prior to servicing appliance, always disconnect
appliance electrical supply cord, if so equipped, from
wall receptacle. If appliance is hard-wired to power
supply, disconnect power to unit by turning off the
proper circuit breaker. Lock service panel to prevent
power from being turned ON accidentally.
• A neutral supply wire must be provided from the
power source (breaker) because critical range
components, including the surface burner spark re-
ignition module, require it to operate safely and
properly.
• Mount the receptacle securely to a wall stud, then seal
around the receptacle's housing.
When using a receptacle it may
2" (51) max.
be necessary to recess the
receptacle's housing into the rear
wall. Refer to Local Electrical
Code to determine the minimum
volume for all electrical / junction
boxes. Follow all local electrical
codes and ordinances, and/or the
National Electric Code, as
applicable.
Volt Circuit
240/208 VAC 50 Amps
Frequency Phase
60 Hz. Single